Stainless Steel Mesh Technical
Stainless Steel Mesh Technical Measuring Technical Food Grade Stainless Steel Mesh  Ancillary Malaysia, Selangor, Kuala Lumpur (KL), Perak, Puchong, Ipoh Supplier, Suppliers, Supply, Supplies | XTS Technologies Sdn Bhd

Measuring Specification

In order to identify specification for inquiries and orders, please refer to the following steps.

figure£ºmeasuring_figure

Please give us detailed conveyor working condition and product be carried in case you are looking for suitable specification for new conveyor system

How to Endless Uni-Flex wire belt

Manual Endless

figure£ºstep1

step1
Remove one piece of wire rod from tail end of belt.
Check the strand direction. The end loop of strand should be in the same direction as the belt end loops. 
 

figure£ºstep2

step2
Bend and Insert the strand in the center of space of wire belt. 
 

figure£ºstep3

step3
Let the straight part of strand bend and curve to interweave the belt.
Try not to twist and deform the shape of Z-bend. 

figure£ºstep4

step4
Insert (¡ù1) arrow marked and push the other side into the belt. Interlock it at (¡ù2) arrow marked point wtih two pliers.
 

figure£ºstep5

step5
Straighten the center space of strand. Insert one side of strand to interlock 2nd space next to center space.
 

figure£ºstep6

step6
Insert around Z-bend as illustrated to interlock perfectly. Straighten the wire. Repeat this procedure till the last space next to end loop. 

figure£ºstep7

step7
Straighten the wire belt roughly. Finish the endless one side completely before starting the opposite side.
 

figure£ºstep8

step8
Put the end loop into the way directed by arrow, and hook up with another end loop.
 

figure£ºstep9

step9
Do the same procudure for the other side of belt and straighten the rod completely.

Applying Joint Sleeve (tubular pipe)

figure£ºstep1

 
step1
Remove a wire rod. Cut even number of spaces of the strand at 3 to 7 where is the position that sprockets and rails are not located.

figure£ºstep2

 
step2
Cut out about 2mm length of the cut piece as illustrated below.

figure£ºstep3

 
step3
Insert cut strands into belt. **Insert a long rod end first.

figure£ºstep4

 
step4
Insert joint sleeve into the cut rods and crimp tightly.
Check carefully the belt face and back when inserting the cut rods.

Climping Tool

We handle the special clipper (crimping tool) and joint sleeve. Please feel free to contact us for details.

picture:clipper

SPACE SPLICING JOINT

SPACE SPLICING JOINT01

SPACE SPLICING JOINT02

  1. 1.Set belts on conveyor with face side (flat-surface) up. Make sure splicing joint piece also has face and back. 
  2. 2.Insert one side of joint piece shown as the above.
 

SPACE SPLICING JOINT03

  1. 3.Connect other side likewise by using pliers.
  2. 4.Each splicing joint should hook at odd columns of spacing.

CONTACT US

  •  
Phone number
+603-8066 2496
E-mail
sales@xtstech.com

Please leave your enquiry here, we will reply as soon as possible.


*only support gif, jpeg, jpg, png, pdf
Switch To Desktop Version